Skoda Workshop Service and Repair Manuals > Yeti > Brake systems | ABS, ADR, TCS, EDL, ESP | Removing and Installing parts of the ABS System on the front and rear axle | Removing and Installing Parts of the ABS System on the Front Axle

Removing and installing wheel speed sensor on the front axle

Removing:

–	Raise vehicle.

–	Separate plug connection -1- wheel speed sensor/wheel speed sensor cable.

–	Release screw -2- from the wheel-bearing housing.

–	Take the ABS-speed sensor out of the wheel bearing housing.

Installing:

–	Clean the inner surface of the hole before inserting the speed sensor and brush over the speed sensor with a hot screw paste -G 052 112 A3-.

–	Insert the wheel speed sensor in the bore of the wheel-bearing housing and tighten the screw.

–	Connect plug connection to wheel speed sensor.

Tightening torque:

Wheel speed sensor in wheel-bearing housing

8 Nm

Skoda Workshop Service and Repair Manuals