skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing sunlight penetration photosensorG107 and sunlight penetration photosensor 2G134 > < Removing and installing Right footwell vent temperature senderG262

Yeti

Removing and installing left vent temperature senderG150 and right vent temperature senderG151
Removing and installing left vent temperature sender -G150- and right vent temperature sender -G151-
Removing
–  Sender on the driver's side - remove the side vent in the dash panel on the driver's side → Chapter.
–  Sender on the front passenger side - remove the glove compartment on the front passenger side → Body Work; Rep. gr.70.
   
–  Disconnect plug connection -1-.
–  Rotate sender -2- by 90° and take out.
Install
Installation is performed in the reverse order, pay attention to the following points:
When installing, pay attention to the correct seating of the gasket ring -3-.
  S87-0329

Removing and installing sunlight penetration photosensorG107 and sunlight penetration photosensor 2G134 > < Removing and installing Right footwell vent temperature senderG262