skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the control motor for fresh air and re-circulating air/air flow flapV425 > < Removing and installing left vent temperature senderG150 and right vent temperature senderG151

Yeti

Removing and installing sunlight penetration photosensorG107 and sunlight penetration photosensor 2G134
Removing and installing sunlight penetration photosensor -G107- and sunlight penetration photosensor 2 -G134 -
–  Switch off the ignition and all electrical components.
   
–  Release screws -1- and remove storage compartment -2-.
  S70-0472
–  Press the housing with sunlight penetration photosensor -1- from underneath out of the dash panel -3- and disconnect the plug -2-.
–  Disconnect plug connection -2-.
–  Installation is carried out in the reverse order.
  S87-0328

Removing and installing the control motor for fresh air and re-circulating air/air flow flapV425 > < Removing and installing left vent temperature senderG150 and right vent temperature senderG151