Skoda Workshop Service and Repair Manuals > Yeti > Heating, ventilation, air conditioning system | Heating, Air conditioning | Air conditioner | Climatronic - Air conditioner with automatic regulation) | Removing and installing the front air distribution flap control motorV426

Removing and installing the front air distribution flap control motorV426

Removing and installing the front air distribution flap control motor -V426-

Removing

–	Switch off the ignition and all electrical components.

–	Left-hand drive - remove dash panel insert → Electrical System; Rep. gr.90.

–	Right-hand drive - remove storage compartment on front passenger side → Body Work; Rep. gr.70.

–	Disconnect the plug connection at the control motor.

–	Unscrew fixing screws -1- and remove control motor.

Install

Installation is performed in the reverse order, pay attention to the following points:

Note

t	After installing the control motor, it is necessary to check the front air distribution flap for proper operation.

t	Carry out the function „Initiate basic setting“ with the Vehicle diagnosis, measurement and information system -VAS 5051-.

Skoda Workshop Service and Repair Manuals