Skoda Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing the heating unit from the vehicle >
< Summary of components, disassembling and assembling the heater unit
Yeti
Heating, ventilation, air conditioning system
Heating, Air conditioning / Heating
Heater control
Removing and installing the bowden wire for temperature flap
Removing and installing the bowden wire for temperature flap
Removing
–
Remove left footwell vent
→ Chapter
.
–
Remove the side cover on the driver's side
→ Body Work; Rep. gr.68
.
–
Fit rotary knob of heater control fully into the position „cold“.
–
Remove the heater control
→ Chapter
.
–
Remove flex shaft for positioning unit of air distribution flaps from the adapter
→ Chapter
.
–
Release the catch
-4-
of the Bowden wire cover
-1-
and take the Bowden wire cover out of the adapter.
–
Release the ball
-2-
from the lever
-3-
of the control.
–
Unclip Bowden wire at the positioning unit for temperature flap
-1-
and at the heater unit
-2-
.
Install
Installation is performed in the reverse order, pay attention to the following points:
–
Make sure that the Bowden wire is positioned through the hook
-arrow-
.
–
Fit on heater control and check whether it is possible to easily turn the temperature knob from „cold“ to „warm“.
Heating, ventilation, air conditioning system
Heating, Air conditioning / Heating
Heater control
Removing and installing the heating unit from the vehicle >
< Summary of components, disassembling and assembling the heater unit