skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Installing and adjusting the clutch > < Removing clutch

Yeti

Preparing the installation of the clutch
   
Preparing the installation of the clutch
Clutch as spare part
1 - Clutch
q   The clutch cover of a new clutch is not secured with a circlip Pos. 5. 5. It sits a little »tight« in the clutch. This should prevent that parts of the clutch fall out when transporting. It can be carefully removed.
2 - Ten circlips
q   the rings have different thicknesses, they are classified in 0.1 mm jumps
q   to this end comply with the instructions in → Chapter
3 - Clutch cover
q   Make sure that the inner sealing lip is not damaged → Chapter.
q   in order to protect the sealing lip, a bush has already been inserted at the manufacturer; please leave this bush in the cover
4 - Circlip
q   for clutch cover
5 - Circlip
q   for clutch cover
q   do not install corrugated circlips
q   always replace → Electronic Catalogue of Original Parts

   
–  Already when taking the clutch out of the package press on the clutch cover.
This should prevent that the clutch cover and the plate support located underneath slip out of the inner plates.
  S30-0167
–  Pay attention to the correct fit of the four piston rings -A-.
  Note
t  The ring joints must not be positioned »above one another«.
t  Slowly turn the rings once, they must operate freely and must not clamp.
  S30-0168
Important! Location of the clutch cover on the clutch
–  Before removing the clutch cover, check if a marking is located on the clutch -arrow A-.
–  If no marking is present, please make a colour coding. At a later stage the »peg« of the clutch cover -arrow B- must be placed again onto this marked point -arrow A-.
–  In case it is installed on a new clutch, remove the circlip -1-.
  S30-0169
–  Carefully remove the clutch cover from the clutch -arrows- and place it to the side.
  Caution
Try to avoid removing or raising the plate support. Not even a little bit! The plates can turn.
Lay aside the clutch in such a way that it cannot fall.
Thus the clutch is prepared for installation → Chapter.
  S30-0170

Installing and adjusting the clutch > < Removing clutch