Yeti
| Four-wheel drive |
Note| t | Fitting position of the shafts and gearshift rods in the gearbox where the reverse gear shift fork is positioned on the shaft for reverse gear shift fork in the clutch housing → Fig.. |
| t | Fitting position of the shafts and gearshift rods in the gearbox where the reverse gear shift fork is positioned on the 5th/6th gear shift rod → Fig.. |
| 1 - | Output shaft gears 1 through 4 |
| q | disassembling and assembling → Chapter |
| 2 - | Gear shift rod with shift fork for 1st and 2nd gear |
| 3 - | Gear shift rod with shift fork for 3rd and 4th gear |
| 4 - | Output shaft 5th, 6th gear/reverse gear |
| q | disassembling and assembling → Chapter |
| 5 - | Gear shift rod with shift fork for 5th and 6th gear |
| 6 - | Gearshift fork reverse gear |
| 7 - | Drive shaft |
| q | disassembling and assembling → Chapter |
| q | Always replace grooved ball bearing on the drive shaft → Chapter |
| 8 - | Reverse shaft |
| q | with thrust washer |
| 9 - | Thrust washer |
| 10 - | Breather |
| q | connect with slave cylinder Pos. 14 |
| 11 - | Clutch housing |
| q | repairing → Chapter |
| 12 - | Gasket ring for drive shaft |
| q | replace → Chapter |
| 13 - | O-ring |
| q | pull onto line connection |
| q | moisten with brake fluid before installing |
| 14 - | Slave cylinder with release bearing |
| q | removing and installing → Chapter |
| 15 - | Screw |
| q | for metal slave cylinder: 12 Nm (without locking agent) |
| q | for plastic slave cylinder: 15 Nm (with locking agent) |
| q | 3 pieces |
| q | always replace → Electronic Catalogue of Original Parts |
| q | carefully tighten in small stages crosswise so that the screw-down eyes of the slave cylinder do not break off |
| 16 - | 33 Nm |
| 17 - | 40 Nm + torque a further 90° |
| q | 4 pieces |
| q | always replace → Electronic Catalogue of Original Parts |
| 18 - | Angle gearbox |
| q | Removing and installing with gearbox fitted → Chapter |
| q | Removing and installing with gearbox removed → Chapter |
| 19 - | Differential gear |
| q | disassembling and assembling → Chapter |
