Yeti
| Summary of components |
Note| Repairs to the clutch → Gearbox; Rep. gr.30. |
| 1 - | 150 Nm + torque a further 180° (1/2 turn) |
| q | replace |
| q | removing and installing → Chapter „Removing and installing crankshaft-belt pulley“ |
| q | The clamping surface of the fixing screw must be free of grease and oil. |
| q | insert oiled (thread) |
| q | Secure belt pulley with counterholder -T30004 (3415)- to prevent it from turning |
| 2 - | Crankshaft-belt pulley |
| q | removing and installing → Chapter |
| q | Clamping surfaces must be free of oil and grease. |
| 3 - | Sealing ring |
| q | replace → Chapter |
| 4 - | Bushing |
| q | Clamping surfaces must be free of oil and grease. |
| 5 - | O-ring |
| q | replace |
| q | in the bushing |
| 6 - | Cylinder head |
| q | removing and installing → Chapter |
| 7 - | 60 Nm + torque a further 1/4 turn (90°) |
| 8 - | Flywheel |
| q | on vehicles with automatic gearbox DSG - two-mass flywheel version |
| q | removing and installing → Chapter |
| 9 - | Intermediate plate |
| q | must be positioned on dowel sleeves |
| q | do not damage/bend during assembly work |
| 10 - | 10 Nm |
| q | replace |
| 11 - | Sealing flange on the gearbox side |
| q | Only replace sealing flange complete with gasket ring and rotor |
| q | removing and installing → Chapter |
| 12 - | Engine speed sender -G28-, 5 Nm |
| q | with captive screw |
| q | removing and installing → Chapter |
