skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Inspecting the exhaust system for leaktightness > < Replacing middle or rear part of the exhaust system

Yeti

Aligning exhaust system free of stress
Aligning exhaust system free of stress
l  The exhaust system is aligned when cold.
   
–  Slacken the nuts at the clamping sleeve -1- and align the intermediate pipe -2- (-arrow- points in direction of travel).
   -a- = 5 mm
  S26-0161
The fixing screws must be on the right. The screws must not protrude beyond the bottom edge of the clamping sleeve -arrow-.
–  Tighten the front nut by hand.
  S26-0195
–  Push the exhaust system so far forward until the dimension -a- of 9…11 mm is achieved between hanger/body and hanger/middle silencer.
–  Tighten bolted connections of the clamping sleeve evenly to 23 Nm.
Align exhaust tailpipes
  S26-0204
–  Align rear muffler in such a way that there is
l  an equal distance between bumper opening and tailpipe -a-.
l  the distance -b- from the bumper opening to the tailpipes is equal.
For centering, if necessary the hangers of the exhaust system must be loosened.
  S26-0216

Inspecting the exhaust system for leaktightness > < Replacing middle or rear part of the exhaust system