Release screws -4- and attach the coolant recirculation pump 2 -V178--3- with the connected hoses to the right side.
For all vehicles
–
Disconnect the plug -1- on the engine speed sender -G28- with the assembly device -T10118- and lay the electrical cable to the side.
Note
To unlock the plug without using the assembly device -T10118-, the unlock button must be pressed at the plug using a screwdriver and at the same time unlock the unlock button with a thin wire hook.
–
Unscrew the fixing screw -arrow- of the engine speed sender -G28- and pull out the sender.
Install
Installation is performed in the reverse order, pay attention to the following points: