skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the sealing flange on the gearbox side > < Summary of components

Yeti

Removing and installing the two-mass flywheel
Removing and installing the two-mass flywheel
Special tools and workshop equipment required
t  Counterholder -MP 1-223 (3067)-
Removing
–  Remove the clutch → Gearbox → Rep. gr.30.
   
–  Rotate two-mass flywheel -A- in such a way that the screws -B- are positioned in the middle of the holes -arrows-.
  S30-0180
–  Insert the counterholder -MP 1-223- into the bore hole on the cylinder block.
t  Fitting position of the counterholder:
   A - to tighten
   B - to release
  Caution
When unscrewing the screws -B-, ensure that no screw head catches on the secondary side -A- of the two-mass flywheel, otherwise the flywheel will be damaged.
–  Unscrew the two-mass flywheel.
Install
Installation is carried out in the reverse order. However, pay attention to the following:
–  Tighten new screws to 60 Nm and torque a further 90° (1/4 turn) (the tightening may occur in several stages).
  S13-0652

Removing and installing the sealing flange on the gearbox side > < Summary of components