Yeti
Summary of components |
1 - | Cylinder block |
q | removing and installing crankshaft → Chapter |
q | Disassembling and assembling pistons and conrods → Chapter |
2 - | Fit pin |
3 - | Sealing flange on the gearbox side |
q | with integrated gasket ring |
q | must be replaced completely |
q | removing and installing → Chapter |
q | Neither grease nor oil sealing lip of gasket ring |
q | before installing remove oil residues on crankshaft journal with a clean cloth |
4 - | 9 Nm |
q | order of tightening → Chapter |
5 - | Intermediate plate |
q | must be positioned on dowel sleeves |
q | do not damage/bend during assembly work |
q | inserted on sealing flange on the gearbox side → Fig. |
6 - | 60 Nm + torque a further 90° (1/4 turn) |
q | replace |
7 - | The two-mass flywheel |
q | removing and installing the two-mass flywheel → Chapter |
q | assembly only possible in one position -holes offset- |
8 - | Fit pin |
|