Skoda Yeti Workshop Service & Auto Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Electronic Engine Power Control (Electronic throttle) >
< Removing and installing suction jet pump
Activated charcoal container system for Yeti 18/112 TSI engine fuel supply (118 kW)
Power unit
1.8/112; 118 kW TSI engine
Fuel supply, gas operation
Activated charcoal container system
Check fuel tank ventilation
Check fuel tank ventilation
Special tools and workshop equipment required
t
Hand vacuum pump, e.g. -V.A.S 6213-
t
Adapter -V.A.G 1318/17-
t
Adapter for K-Jetronic tester -V.A.G 1318/20-1-
Test condition
l
The ignition must be switched off.
Test sequence
–
Detach vent line
-1-
. To do so press in the securing ring.
–
Then connect the hand vacuum pump -V.A.S 6213-
-1-
to the vent line
-2-
as shown.
–
Operate the hand vacuum pump -V.A.S 6213- several times.
l
No vacuum should build up.
If a vacuum builds up.
–
Check the air admission fitting on the activated charcoal filter for dirt and clean as required.
If no vacuum builds up:
–
Shut off air admission fitting
-arrow-
and once again operate the hand vacuum pump several times. A vacuum should build up.
If no vacuum builds up:
–
Replace activated charcoal filter.
Power unit
1.8/112; 118 kW TSI engine
Fuel supply, gas operation
Activated charcoal container system
Electronic Engine Power Control (Electronic throttle) >
< Removing and installing suction jet pump