Skoda Workshop Service and Repair Manuals

Aligning exhaust system free of stress l  The exhaust system is aligned when cold.

–  Slacken the nuts at the clamping sleeve -1- and align the intermediate pipe -2- (-arrow- points in direction of travel).    -a- = 5 mm

The fixing screws must be located on the right. The screws must not protrude beyond the bottom edge of the clamping sleeve -arrow-. –  Tighten the front nut by hand. For the vehicles Fabia II, Roomster

–  Push the middle and rear silencer forward until the dimension -a- = 3 ... 7 mm is obtained on the retaining strap/middle silencer. For the vehicles Octavia II, Yeti

–  Push the exhaust system so far forward until the dimension -a- of 7…9 mm is achieved between hanger/body and hanger/middle silencer. Continued for all vehicles –  Tighten bolted connections of the clamping sleeve evenly to 23 Nm.

Align the exhaust tailpipe version l. –  Align rear silencer in such a way that there is an equal distance -a- right and left between bumper opening and exhaust tailpipe. –  For centering the exhaust tailpipe, if necessary loosen the suspension of the rear silencer. Align the exhaust tailpipes version ll.

–  Align rear muffler in such a way that there is l  an equal distance -a- between bumper opening and exhaust tailpipe. l  the distance -b- from the bumper opening to the exhaust tailpipes is equal. For centering, if necessary the hangers of the exhaust system must be loosened.