skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Ignition system, glow plug system > < Exhaust gas recirculation system

Yeti

Replacing middle or rear part of the exhaust system
Replacing middle or rear part of the exhaust system
Special tools and workshop equipment required
t  Body saw, e.g. -V.A.G 1523 A- or chain pipe cutter, e.g. -VAS 6254-
t  Protective goggles
Work procedure
  Note
t  For individually replacing the middle or rear part of the exhaust system, a separation point is provided in the connecting pipe.
t  The separation point is marked by indentations on the circumference of the exhaust pipe.
  WARNING
In order to avoid injuries because of metal swarfs, wear safety goggles and safety clothing.
   
–  Separate exhaust pipe at right angles at the separation point -arrow 2-.
–  When installing, position clamping sleeve -4- at the side markings -arrow 1- and -arrow 3-.
–  Turn the clamping sleeve -4- in such a way that the ends of the screws are as far upwards as possible.
–  Align rear part of exhaust system horizontally and tighten clamping sleeve to 25 Nm.
–  Align exhaust system free of stress → Chapter.
  S26-0147

Ignition system, glow plug system > < Exhaust gas recirculation system