–
| Fit the plug -2- onto the accelerator pedal module -5- → Chapter. |
–
| Push again rubber grommet -1- onto the connector -2-. |
–
| Push accelerator pedal module onto the retaining bolts -6-. |
–
| Insert the centering pin -7- into the hole in the underbody. |
–
| Screw on accelerator pedal module with fixing screws -3-, tighten to 10 Nm and push on cap -4-. |
–
| Install steering column cover. |
–
| If the accelerator pedal module was replaced, an adaptation of the engine control unit has to be performed on vehicles with automatic gearbox → Vehicle diagnostic tester. |
|
|
|