skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing parts of the fuel supply system > < Measures in case of misfuelling

Yeti

Removing and installing accelerator pedal module
Removing and installing accelerator pedal module
Special tools and workshop equipment required
t  Release tool -T10238- (for left-hand drive vehicle)
t  Release tool -T10240- (for right-hand drive vehicle)
Removing
   
–  Remove steering column cover -arrows-.
–  Disconnect connector at accelerator pedal module → Chapter.
–  Lever out the cap (Pos. 4) with a screwdriver.
–  Release fixing screw (Pos. 3).
  S20-0134
–  Push the release tool -T10238- (for right-hand drive vehicles release tool -T10240-) as shown up to the stop into the provided openings.
–  Disconnect connector at accelerator pedal module → Chapter.
–  Remove accelerator pedal module.
Install
  S20-0175
–  Fit the connector -2- onto the accelerator pedal module -5- → Chapter.
–  Push again rubber grommet -1- onto the connector -2-.
–  Push accelerator pedal module onto the fixing bolts -6-.
–  Insert the centering pin -7- into the hole in the underbody.
–  Screw on the accelerator pedal module with the fixing screw -3-, tighten to 10 Nm and fit on the cap -4-.
–  Re-install steering column cover.
  Note
If the accelerator pedal module was replaced on vehicles with automatic gearbox, the engine control unit must be adapted → Vehicle diagnostic tester.
  S20-0270

Removing and installing parts of the fuel supply system > < Measures in case of misfuelling