ForTwo L3-1.0L (2009)
3
Lay crossmember (4) into vehicle, insert assembly wedge (12) into crossmember (4) and close doors.
The assembly wedge (12) should be in the lowest position
4
Position crossmember (4) in vehicle and secure against falling down with one drift (5) each on left and right.
Aid of helper required
5
Completely unscrew knurled screw (13) and position push-in device (14) as shown.
6
Loosely screw in bolts (6, 7, 8, 9) for crossmember (4).
Aid of helper required Ensure that bolts (6, 7, 8, 9) do not fall into A-pillar opening.
7
Align installation position of crossmember (4) according to specified adjustment dimensions (a to c) in relation to firewall (10) and vehicle floor
carrier (11).
Dimension a = outer edge of crossmember (area of lower bearing shell) to firewall, dimension b = outer edge of crossmember (area of rear
H-profile) to firewall, dimension c = lower edge of crossmember (area of lower H-profile) to vehicle floor carrier.
