B9 Tribeca F6-3.0L DOHC (2006)
Transmission Speed Sensor: Service and Repair
Front Vehicle Speed Sensor
Front Vehicle Speed Sensor
REMOVAL
1. Remove the transmission assembly from vehicle body.
2. Remove the rear vehicle speed sensor.
NOTE: Secure the harness of the rear vehicle speed sensor to the transmission body using wire etc.
3. Remove the extension case.
4. Remove the center differential carrier.
5. Lay along the transmission case, and then remove the oil pan.
6. Remove the old gasket on the oil pan and transmission case completely.
7. Disconnect the front vehicle speed sensor connector.
8. Remove the front vehicle speed sensor securing bolt.
9. Remove the front vehicle speed sensor through the hole of AT transmission main case.
INSTALLATION
1. Install the front vehicle speed sensor.
Tightening torque: 7 Nm (0.7 kgf-m, 5.2 ft. lbs.)
