Baja F4-2.5L SOHC (2003)
5. Disconnect connector from VDCCM by pulling up the securing holder.
6. Remove VDCCM.
INSTALLATION
Install in the reverse order of removal.
CAUTION: After completion of installation procedure, the following two position settings must be made.
^
Steering angle sensor center positioning
^
Yaw rate and lateral G sensor 0 positioning These procedures are necessary for VDCCM to later recognize what position the vehicle is in. For
procedures for the above two settings, <Ref. to ADJUSTMENT, VDC Control Module (VDCCM).>.
VDCCM Connector Cover
VDCCM Connector Cover
REMOVE
1. Turn ignition switch OFF.
2. Disconnect connector from VDCCM.
3. Remove band.
4. Remove cable clamp cover.
5. Remove screws securing connector cover.
CAUTION: Do not allow harness to catch on adjacent parts during installation.
6. Remove connector cover.
INSTALLATION