Baja F4-2.5L SOHC (2003)
Engine Oil Pressure: Testing and Inspection
Engine Oil Pressure
INSPECTION
1. Disconnect battery ground cable.
2. Remove generator from bracket.
3. Disconnect connector from oil pressure switch.
4. Remove oil pressure switch from engine cylinder block.
5. Connect oil pressure gauge hose to cylinder block.
6. Connect battery ground cable.
7. Start the engine, and measure oil pressure.
Oil pressure: 88 kPa (0.9 kg/cm2, 13 psi) or more at 800 rpm 94 kPa (3.0 kg/cm2, 43 psi) or more at 5,000 rpm
CAUTION:
^
If oil pressure is out of specification, check oil pump, oil filter and lubrication line.
^
If oil pressure warning light is turned ON and oil pressure is in specification, replace oil pressure switch.
NOTE: The specified data is based on an engine oil temperature of 80°C (176°F).
8. After measuring oil pressure, install oil pressure switch.
Tightening torque: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
9. Install generator and V-belt in the reverse order of removal, and adjust the V-belt deflection.