Baja F4-2.5L SOHC (2003)
5. After ensuring that the marks on timing belt and camshaft sprockets are aligned, remove stopper pin from belt tensioner adjuster.
6. Install timing belt guide. (MT vehicles only)
1. Temporarily tighten bolts.
2. Check and adjust clearance between timing belt and timing belt guide by using thickness gauge.
Clearance: 1.0 +/- 0.5 mm (0.039 +/- 0.020 inch)
3. Tighten bolts.
Tightening torque: 9.8 Nm (1.0 kgf-m, 7.2 ft. lbs.)
7. Install belt cover.
8. Install crankshaft pulley.
9. Install V-belt.
INSPECTION
TIMING BELT
1. Check timing belt teeth for breaks, cracks, and wear. If any fault is found, replace belt.
2. Check the condition of back side of belt; if any crack is found, replace belt.
CAUTION:
^
Be careful not to let oil, grease or coolant contact the belt. Remove quickly and thoroughly if this happens.