Baja F4-2.5L SOHC (2003)
Throttle Position Sensor: Adjustments
ADJUSTMENT
1. Turn ignition switch to OFF.
2. Loosen throttle position sensor holding screws.
3. When using voltage meter;
1. Take out ECM.
2. Turn ignition switch to ON.
3. Adjust throttle position sensor to the proper position to allow the voltage signal to ECM to be in specification.
Connector & terminal / Specified voltage
(B135) No. 13 - (B135) No. 19 / 0.45 - 0.55 V [Fully closed.]
4. Tighten throttle position sensor holding screws.
Tightening torque: 2.4 N.m (0.24 kgf-m, 1.7 ft-lb)
4. When using Subaru Select Monitor;
1. Turn ignition switch to OFF.