Baja F4-2.5L SOHC (2003)
-
Each test should be conducted within 3 to 5 seconds. Power to be furnished should be one-half the rated voltage.
1. Pull-in test
Connect two battery negative leads onto magnetic switch body and terminal C respectively. Then connect battery positive lead onto terminal 50.
Pinion should extend when lead connections are made.
2. Holding-in test
Disconnect lead from terminal C with pinion extended. Pinion should be held in the extended position.
3. Return test
Connect two battery negative leads onto terminal 50 and onto terminal 50 and onto switch body respectively. Then connect battery positive lead
onto terminal C. Next, disconnect lead from terminal 50. Pinion should return immediately.
PERFORMANCE TEST
The starter is required to produce a large torque and high rotating speed, but these starter characteristics vary with the capacity of the battery. It is
therefore important to use a battery with the specified capacity whenever testing the starter. The starter should be checked for the following three items:
-
No-load test