Baja F4-2.5L SOHC (2003)
6. Apply compressed air intermittently to check for operation.
7. Check the clearance and select retaining plate.
8. Install 2-4 brake.
9. Install planetary gear and low clutch assembly to transmission case.
Install carefully while rotating the low clutch and planetary gear assembly slowly paying special attention not to damage the seal ring.
10. Install the high clutch assembly.
11. Install the oil pump housing assembly.
12. Install control valve assembly and oil pan.
13. Install the torque converter clutch case assembly.
14. Install reduction driven gear.
15. Install reduction drive gear. (MPT model)
16. Install the center differential carrier. (VTD model)
17. Install the extension case to the transmission case.
18. Install the rear vehicle speed sensor.
Tightening torque: 7 Nm (0.7 kgf-m, 5.1 ft. lbs.)
19. Insert inhibitor switch and transmission connector into stay.
20. Install air breather hose.
21. Install the oil cooler pipes.
22. Install the oil charger pipe with O-ring.
23. Insert the input shaft while turning lightly by hand. At this time, not to damage the bushing.
Normal protrusion A: 50 - 55 mm (1.97 - 2.17 inch)
24. Install the torque converter clutch assembly.
25. Install the transmission assembly to the vehicle.
DISASSEMBLY
ONE-WAY CLUTCH INNER RACE