Baja F4-2.5L SOHC (2003)
Fluid Line/Hose: Service and Repair
ATF Cooler Pipe and Hose
REMOVAL
EXCEPT 3.0 L MODEL
1. Set the vehicle on a lift.
2. Remove battery and washer tank.
3. Lift-up the vehicle.
4. Remove the under cover.
5. Disconnect ATF cooler hose from radiator.
NOTE:
^
Do not remove with a screwdriver or other pointed tools.
^
When the hose is difficult to remove, wrap a shop cloth around the hose to protect it. Turn it with pliers, and then pull directly out with your
hand.
6. Disconnect ATF cooler hoses from pipes.
NOTE:
^
Do not remove with a screwdriver or other pointed tools.
^
When the hose is difficult to remove, wrap a shop cloth around the hose to protect it. Turn it with pliers, and then pull directly out with your
hand.
INSTALLATION
EXCEPT 3.0 L MODEL
1. Install the oil cooler outlet and inlet pipes.
NOTE: Be sure to use a new aluminum washer.
Tightening torque:
T1: 44 Nm (4.5 kgf-m, 32.5 ft. lbs.)
T2: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)