Baja F4-2.5L SOHC (2003)
3. Remove circlip from SFJ outer race using screwdriver.
4. Remove SFJ outer race from shaft assembly.
5. Wipe off grease.
CAUTION: The grease is a special grease. Do not confuse with other greases.
6. Place alignment mark on free ring and trunnion.
7. Remove free ring from trunnion.
CAUTION: Be careful with the free ring position.
8. Place alignment mark on trunnion and shaft.
9. Remove snap ring and trunnion.
CAUTION: Be sure to wrap shaft splines with vinyl tape to prevent boot from scratches.