Baja F4-2.5L SOHC (2003)
CAUTION: Use a new band.
20. Pinch the end of band with pliers. Hold the clip and tighten securely.
NOTE: When tightening boot, exercise care so that the air within the boot is appropriate.
21. Tighten band by using ST.
ST 925091000 BAND TIGHTENING TOOL
NOTE: Tighten band until it cannot be moved by hand.
22. Tap on the clip with the punch provided at the end of ST.
ST 925091000 BAND TIGHTENING TOOL
CAUTION: Tap to an extent that the boot underneath is not damaged.
23. Cut off band with an allowance of about 10 mm (0.39 inch) left from the clip and bend this allowance over the clip.
CAUTION: Be careful so that the end of the band is in close contact with clip.
24. Fix up boot on BJ in the same manner.
NOTE: Extend and retract SFJ to provide equal grease coating.
Front Drive Shaft Inspection
INSPECTION
Check the removed parts for damage, wear, corrosion etc. If faulty, repair or replace.
1. DOJ (Double Offset Joint)
^
Check seizure, corrosion, damage, wear and excessive play.
2. SFJ (Shudder-less Free-ring tripod Joint)
^
Check seizure, corrosion, damage and excessive play.
3. Shaft
^
Check excessive bending, twisting, damage and wear.
4. BJ (Bell Joint)
^
Check seizure, corrosion, damage and excessive play.
5. Boot
^
Check for wear, warping, breakage or scratches.
6. Grease
^
Check for discoloration or fluidity.
Rear Drive Shaft Removal
REMOVAL