Baja F4-2.5L SOHC (2003)
Transmission Speed Sensor: Service and Repair
Front Vehicle Speed Sensor
Front Vehicle Speed Sensor
REMOVAL
1. Set the vehicle on a lift.
2. Disconnect the ground cable from battery.
3. Remove the air cleaner case. (2.5 L model)
4. Remove air intake chamber. (3.0 L model)
5. Disconnect the transmission connector.
6. Remove the pitching stopper.
7. Remove the transmission connector from stay.
8. Lift-up the vehicle.
9. Clean the transmission exterior.
10. Drain the ATF completely.
NOTE:
^
Tighten the ATF drain plug after draining the ATF.
^
Replace the gasket with a new one.
Tightening torque: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
11. Remove the front, center, rear exhaust pipes and muffler.
12. Remove the shield cover.
13. Remove the propeller shaft.
14. Place the transmission jack under transmission.