Forester F4-2.5L DOHC Turbo (2007)
2) Remove the piston boot.
3) Place a wooden block as shown in the figure to prevent damage to the piston. Gradually supply compressed air via inlet of the brake hose to force
piston out.
4) Remove the piston seal from caliper body cylinder.
CAUTION: Be careful not to scratch the inner surface of cylinder and piston seal groove.
5) Remove the lock pin sleeve and boot from caliper body.
6) Remove the guide pin boot.
14 INCH TYPE
1) Clean the caliper body interior using brake fluid.
2) Apply a coat of brake fluid to the piston seal and fit piston seal in groove on caliper body.
3) Apply a coat of brake fluid to the entire inner surface of cylinder and outer surface of piston.
4) Insert the piston into cylinder.
CAUTION: Do not force piston into cylinder.
5) Apply a coat of specified grease to the boot and fit in groove on ends of cylinder and piston.
Grease: NIGLUBE RX-2 (Part No. K0779GA102)
