Forester F4-2.5L DOHC Turbo (2007)
6) After confirmation of the ABS sensor clearance, connect the connector to ABS sensor.
7) Connect the battery ground cable to battery.
INSPECTION
ABS SENSOR
1) Check the pole piece of ABS sensor for foreign particles or damage. If necessary, clean the pole piece or replace ABS sensor.
2) Measure the ABS sensor resistance.
If resistance is outside the standard value, replace the ABS sensor with a new one.
NOTE: Check the ABS sensor cable for discontinuity. If necessary, replace with a new one.
SENSOR GAP
Measure clearance between tone wheel and ABS sensor at whole periphery.
NOTE:
^
If clearance is narrow, adjust by using spacer (Part No. 26755AA000).
^
If clearance is wide, check the outputted voltage then replace the ABS sensor or tone wheel if the outputted voltage is outside specification.
ABS sensor clearance: 0.7 - 1.2 mm (0.028 - 0.047 inch)
OUTPUT VOLTAGE
Output voltage can be checked by the following method. Install the resistor and condenser, then rotate the wheel about 2.75 km/h (2 MPH) or
equivalent.
Output voltage specification: 0.12 - 1 Volt (at 20 Hz)
