Forester F4-2.5L DOHC Turbo (2007)
Clutch Switch: Service and Repair
Clutch Switch
REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the instrument panel lower cover.
3. Disconnect the connector from the clutch switch.
4. Remove the clutch switches.
INSTALLATION
1. CLUTCH SWITCH
1. Install so that there is a gap of 0 mm (0 inch) of the clutch switch and clutch pedal stopper.
Tightening torque: 8 Nm (0.8 kgf-m, 5.8 ft. lbs.)
2. Measure the stroke of the clutch pedal.
Clutch pedal standard full stroke: A 130 - 135 mm (5.12 - 5.31 inch)
3. If the clutch pedal stroke is out of specification, adjust the stroke.
4. Connect the clutch switch connector.
2. CLUTCH SWITCH (CLUTCH START)
1. Fully depress the clutch and hold it.
2. Set the clearance of clutch pedal plate and clutch switch to 3 - 3.5 mm (0.12 - 0.14 inch) and tighten the lock nut.
Tightening torque: 8 Nm (0.8 kgf-m, 5.8 ft. lbs.)