Forester F4-2.5L DOHC Turbo (2007)
If any damage, opening, or rust is found on the airbag system wire harness, do not attempt to repair using soldering equipment. Be sure to replace the
faulty harness with a new genuine part.
Install the wire harness securely with the specified clips to avoid interference or tangled up with other parts.
Do not allow water or oil to come in contact with the connector terminals. Do not touch the connector terminals.
Either of the airbag modules for driver, passenger or side, or pretensioner must not be disassembled.
The airbag module cannot be used again once inflated.