Forester F4-2.5L DOHC Turbo (2007)
10. Remove the nut that fastens the clutch master cylinder.
11. Remove the bolt and nut that fastens the brake pedal and clutch pedal and remove the pedal assembly.
INSTALLATION
1. Install in the reverse order of removal.
Tightening torque: 18 Nm (1.8 kgf-m, 13.0 ft. lbs.)
NOTE:
^
If the cable clamp is damaged, replace it with a new one.
^
Always cover the outer cable end with the boot.
^
Be careful not to twist the accelerator cable.
^
Always use a new clevis pin.
2. Adjust the clutch pedal after installation.
3. Adjust the clutch switch (clutch start).
4. Adjust the heel holder. (Model with heel holder)
DISASSEMBLY
1. Remove the clip, assist spring, rod and bushing.
