Forester F4-2.5L DOHC Turbo (2007)
11. Install the circlip in the groove on the DOJ outer race.
CAUTION:
^
Make sure that the balls, cage and inner race are firmly fitted in the outer race of the DOJ.
^
Take care not to place the matching position of the circlip in the ball groove of outer race.
^
Pull the shaft lightly to make sure that the circlip is completely fitted in the groove.
12. Apply an even coat of the specified grease [20 to 30 g (0.71 to 1.06 oz)] to the entire inner surface of boot. Also apply grease to the shaft.
13. Install the DOJ boot taking care not to twist it.
NOTE:
^
The inside of the larger end of DOJ boot and the boot groove is to be cleaned so as to be free from grease and other foreign substances.
^
When installing the DOJ boot, position the outer race of DOJ at center of the stroke.
14. Put a new band through the clip and wind twice in the band groove of the boot.
15. Pinch the end of band with pliers. Hold the clip and tighten securely.
CAUTION: When tightening the boot, exercise care so that the air within the boot is appropriate.
16. Tighten the band using the ST.
ST 925091000 BAND TIGHTENING TOOL
CAUTION: Tighten the band until it cannot be moved by hand.
17. Tap the clip with the punch provided at the end of the ST.
ST 925091000 BAND TIGHTENING TOOL
CAUTION: Tap to an extent that the boot underneath is not damaged.
