Forester F4-2.5L SOHC (2004)
2. Loosen the throttle position sensor holding screws.
NOTE: For detailed operation procedures, refer to the Subaru Select Monitor Operation Manual.
3. Insert the cartridge to the Subaru Select Monitor.
4. Connect the Subaru Select Monitor to the data link connector.
5. Turn the ignition switch to ON, and the Subaru Select Monitor switch to ON.
6. Select the {2. Each System Check} in Main Menu.
7. Select the {Engine Control System} in Selection Menu.
8. Select the {1. Current Data Display & Save} in Engine Control System Diagnosis.
9. Select the {1.12 Data Display} in Data Display Menu.
10. Adjust the throttle position sensor to the proper position to match with the following specifications.
Condition: Throttle fully closed
Throttle opening angle 0.00 %
Throttle sensor voltage 0.50 V
11. Tighten the throttle position sensor holding screws.
