Forester F4-2.5L SOHC (2004)
Steering Wheel: Service and Repair
Steering Wheel
REMOVAL
1) Disconnect the ground cable from battery.
2) Set the tires to straight-ahead position.
3) Remove the airbag module.
WARNING: Always refer to "Air Bag System" before performing airbag module service.
4) Make matching marks on the steering wheel and steering shaft.
5) Remove the steering wheel nut, and then draw out the steering wheel from shaft using steering puller.
INSTALLATION
WARNING: Always refer to "Air Bag System" before performing airbag module service.
1) Align the center of roll connector.
2) Install in the reverse order of removal.
NOTE: Align matching marks on the steering wheel and steering shaft.
Tightening torque: 45 Nm (4.6 kgf-m, 33.2 ft. lbs.)
Column cover-to-steering wheel clearance: 2 - 4 mm (0.08 - 0.16 inch)
CAUTION: Insert the roll connector guide pin into guide hole on lower end of surface of steering wheel to prevent damage.
INSPECTION
1) Check the steering wheel for deformation. If the deformation is excessive, replace steering wheel.
2) Check the splines on steering wheel for damage. If the damage is excessive, replace steering wheel.
