Forester F4-2.5L SOHC (2004)
Assemble in the reverse order of disassembly.
CAUTION: Install the front bushing in correct direction, as shown in the figure.
REAR BUSHING
1) Install the rear bushing to transverse link and align aligning marks scribed on the two.
2) Tighten a new self-locking nut.
NOTE: While holding the rear bushing so as not to change position of aligning marks, tighten the self-locking nut.
Tightening torque: 190 Nm (19.4 kgf-m, 140 ft. lbs.)
INSPECTION
1) Check the transverse link for wear, damage and cracks, and correct or replace if defective.
2) Check the bushings for cracks, fatigue or damage.
3) Check the rear bushing for oil leaks.
