Forester F4-2.5L SOHC (2004)
Clutch: Service and Repair
High Clutch and Reverse Clutch
High Clutch and Reverse Clutch
REMOVAL
1. Remove the transmission assembly from the vehicle.
2. Extract the torque converter clutch assembly.
3. Remove the input shaft.
4. Lift-up lever behind the transmission harness connector and disconnect it from stay.
5. Disconnect inhibitor switch connector from stay.
6. Disconnect the air breather hose.
7. Remove the oil charger pipe
8. Remove the oil cooler inlet and outlet pipes.
9. Separation of torque converter clutch case and transmission case.
10. Remove the oil pump housing.
11. Take out the high clutch, thrust needle bearing and reverse clutch assembly.
12. Take out the high clutch hub and the thrust bearing.
INSTALLATION
1. Apply Vaseline to thrust needle bearing.