Forester F4-2.5L SOHC (2004)
21. Set the inner race. Make sure that the forward clutch is free in the clockwise direction and locked in the counterclockwise direction, as viewed
from the front of the vehicle.
INSPECTION
1. Inspect the following items.
^
Drive plate facing for wear and damage
^
Snap ring for wear, return spring for breakage or setting, and spring retainer for deformation
^
Lip seal and lathe cut seal ring for damage
^
Piston check ball for operation
^
Measure the total end play and adjust to within specifications.
2. Place the same thickness of shim on both sides to prevent retaining plate from tilting.
3. Inspect clearance between retaining plate and operation of the low clutch.
Standard value: 0.7 - 1.1 mm (0.028 - 0.043 inch)
Allowable limit: 1.6 mm (0.063 inch)
