Forester F4-2.5L SOHC (2004)
20. Take out retaining plate, drive plate, driven plate and dish plate.
21. Turn the transmission case upside down, and then take out the socket bolts while holding the one-way clutch inner race with hand.
INSTALLATION
1. Install the one-way clutch inner race, spring retainer and return spring.
2. Tighten socket head bolts evenly from the rear side of the transmission case.
Tightening torque: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
3. Place transmission case with the front facing up.
4. Install thrust needle bearing.
5. Installation of the low & reverse brake: Install dish plate, driven plates, drive plates, and a retaining plate, and secure with a snap ring.
NOTE: Pay attention to the orientation of the dish plate.