Forester F4-2.5L SOHC (2004)
Wiper Motor: Service and Repair
Front Wiper Motor and Link
Front Wiper Motor and Link
REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the cowl panel.
3. Disconnect the connector of motor.
4. Loosen the bolts and nuts to remove wiper link.
5. Loosen the bolts and nuts to remove motor.
INSTALLATION
1. Install the wiper link to the vehicle, and then connect the motor connector.
2. Connect the battery ground cable to battery.
3. To confirm that the motor is at auto stop position, turn the wiper switch ON/OFF once.
4. Disconnect the ground cable from battery.
5. Tighten the nut where rod (A) and link plate (B) is aligned in a straight line.
6. Install in the reverse order of removal.
