Forester F4-2.5L Turbo (2009)
Note:
Allow at least 48 hours for paint to dry before installing film.
Note:
If film replacement is required on one side, both sides must be replaced at the same time.
Protective film taped into place for illustration purposes.
Remove the old film. Using mild detergent mixed with water, clean the area that will be covered with the new film. Clean a second time using
rubbing alcohol.
Note:
Vehicle and film must be at room temperature for proper adhesion. Do not install protector film dry.
Spray the area of the rear door where the protective film will be installed with mild detergent mixed with water.
The protector film consists of 3 layers, white backing, protector film and template.
Remove white backing from protector film and template. Spray the protector film and template (the side which the white backing was removed)
with mild detergent mixed with water.
