Forester F4-2.5L Turbo (2009)
CAUTION: Be careful not to allow foreign matter to enter into inspection hole.
11) Align the center of roll connector.
12) Apply the grease provided with the new part on the four locations of the protrusion on the steering angle sensor.
13) Align the position of the protrusion and install roll connector to steering angle sensor.
Tightening torque: 0.5 N-m (0.05 kgf-m, 0.36 ft-lb)
14) Install the roll connector to combination switch and bind the harness with vinyl tape as originally bound.
15) Install the steering wheel.
Tightening torque: 39 N-m (4.0 kgf-m, 28.8 ft-lb)
