Forester F4-2.5L Turbo (2009)
4) After tightening the camshaft cap, ensure the camshaft rotates only slightly while holding it at base circle.
3) Apply a coat of engine oil to the camshaft oil seal periphery and oil seal lips, then install the oil seal on the camshaft using ST1 and ST2.
NOTE: Use a new oil seal.
ST1 499587600 OIL SEAL INSTALLER
ST2 499597200 OIL SEAL GUIDE
4) Install the oil pipe.
NOTE: Make sure not to mix up the union screws with filter and without filter as their installation positions are different.
Tightening torque: 29 N-m (3.0 kgf-m, 21.4 ft-lb)
5) Similarly, install the parts on right-hand side.
6) Install the tensioner bracket.
Tightening torque: 24.5 N-m 2.5 degrees, kgf-m, 18.1 ft-lb)
