Forester F4-2.5L Turbo (2009)
3) Tighten the bolt (A).
4) Tighten the slider bolt (B).
Tightening torque:
Bolt (A): 25 N-m 2.5 degrees, kgf-m, 18.4 ft-lb)
Slider bolt (B): 8 N-m (0.8 kgf-m, 5.9 ft-lb)
5) Install the collector cover bracket.
Tightening torque:
T1: 8.5 N-m (0.9 kgf-m, 6.3 ft-lb)
T2: 25 N-m 2.5 degrees, kgf-m, 18.4 ft-lb)
6) Install the air intake duct (rear).
7) Install the collector cover.
REAR SIDE BELT
CAUTION:
^
Always use new rear side belt.
^
Be careful that the new rear side belt does not come into contact with any oil, grease or coolant.
^
Be careful when touching the belt. If the end face of the belt is rubbed by hand, you may receive injury from bared wires.
^
When installing the rear side belt, always use the provided tools (belt stopper, belt guide, belt guide holder and bolt).
