Forester F4-2.5L Turbo (2009)
INSTALLATION
NOTE: Before installing the oil pan, clean the mating surface of oil pan and engine block.
1) Make sure that the seals (A) are installed securely on the baffle plate in a direction as shown in the figure below.
NOTE: Use new seals.
2) Install the baffle plate.
Tightening torque: 6.4 N-m (0.7 kgf-m, 4.7 ft-lb)
3) Install the oil strainer to the cylinder block.
NOTE: Use new O-rings.
Tightening torque: 10 N-m (1.0 kgf-m, 7.2 ft-lb)
4) Tighten the oil strainer stay together with the baffle plate.
Tightening torque: 6.4 N-m (0.7 kgf-m, 4.7 ft-lb)
5) Apply liquid gasket to the mating surfaces of the oil pan, and install the oil pan.
NOTE:
^
Use a new gasket.
^
Install within 5 min. after applying liquid gasket.
Liquid gasket: THREE BOND 1217G (Part No. K0877Y0100) or equivalent
