Forester F4-2.5L Turbo (2009)
Headlamp Alignment Sensor: Service and Repair
Front Height Sensor
Front Height Sensor
REMOVAL
CAUTION: Always remove the vehicle height sensor before removing any parts related to the suspension.
1. Disconnect the ground cable from the battery.
2. Lift up the vehicle and remove the left front wheel.
3. Remove the under cover.
4. Disconnect the sensor connector.
5. Remove the bracket from the front crossmember.
6. Remove the bracket from the transverse link.
CAUTION: Do not disassemble the sensor and lever.
INSTALLATION
1. Align the bracket clip with the front crossmember installation hole, and install the bracket.
2. Install in the reverse order of removal.
Tightening torque: 7.5 N.m (0.76 kgf.m, 5.5 ft.lb)
NOTE: Perform reinitialization if the front vehicle height sensor was removed.
