Forester F4-2.5L Turbo (2009)
9) Place the rib face of the rear side belt onto the grooves of the crank pulley, and sandwich the rear side belt with the belt guide holder.
CAUTION: If the rear side belt does not fit onto the groove of the crank pulley easily, pull out the belt guide holder halfway, then insert the
rear side belt into the groove, and sandwich it with the belt guide holder.
10) Place the tool through the loop of the rear side belt, and set on the crank pulley belt.
11) While checking for the following, turn the crank pulley slowly to the right by approximately 900 and set the belt guide to the position shown in the
figure.
CAUTION: When rotating the crank pulley, be careful that the belt guide does not deviate from the groove of the crank pulley.
