Forester F4-2.5L Turbo (2009)
Engine Control Module: Service and Repair
Engine Control Module (ECM)
REMOVAL
1. Disconnect tine ground cable from battery.
2. Remove the glove box lower cover.
3. Remove the lower inner trim of passenger's side.
4. Turn over the floor mat of passenger's seat.
5. Remove the protect cover.
6. Remove the bolts and nuts which hold the ECM to the bracket.
7. Disconnect the ECM connectors, and take out the ECM.
INSTALLATION
Install in the reverse order of removal.
CAUTION:When the ECM on a model with immobilizer has been replaced, be sure to perform registration of the immobilizer. (Refer to the
"PC application help for Subaru Select Monitor".)
NOTE: When replacing the ECM, be careful not to use the wrong spec. ECM to avoid any damage on the fuel injection system.
Tightening torque: 7.5 N.m (0.8 kgf.m, 5.5 ft.lb)
